Heartland 3630, 3530 installation and operation guide Clearance Diagrams 30 Metro, Dim Metro

			Section 1: Set Up and Assembly
Clearance Diagrams - 30” Metro		Dim	30" Metro
		A1	28 3/4" (73cm)
			to front of stove
		A2	31 1/4" (79 cm)
			to edge of oven door handle
		B	36 1/8" (92cm)
		C	29 3/4" (76cm)
		D	17 1/2" (45cm)
		E1	standard 40 5/8" (103cm)
		E2	low profile: 38" (97cm)
		E3	high back w/shelf:
			56 1/8" (143cm)
Clearances	Figure 1		Table 1

•Oven door vents must be 2" from any combustible. Door vents are required on Metro units to allow oven door ventilation.

•Minimum distance between the range and a side wall above the cooking top surface is 6” (see dim "O" in Table 2 below)

Electrical requirements:

•Electrical hookup must be done by a licenced electrician

•240 Volts 60Hz 4.1 kW three prong plug for U.S. and four prong for Canadian installations. (5 ft-1.5 m power cord included) New installations for the U.S. may require a four prong plug, please confirm prior to ordering.

Gas Requirements:

•Gas hook-up must be done by a licensed gas fitter.

•Pressure requirements: Natural gas: 6” W.C. (min); LP gas: 11” W.C. (min)

• Connection: 1/2” NPT • 5/8” minimum diameter flex line.

•An accessible manual shut off valve must be installed at the appliance.

•Natural Gas/Propane Conversion kits are available - must be done by a licensed gas fitter

For proper performance a 450 CFM vent hood is required on all 30" Legacy ranges to en- sure adequate and proper ventilation. For su- perior ventilation we recommend using a 36” hood, how- ever a 30” hood is adequate.

Anti Tip Bracket: When properly in- stalled, will pre- vent stove from

bracket included with every stove.

Dim	30" Metro
G	Maximum 26"" (66cm)

Q

tipping forward if downward force is applied to an open door.

H	36" (92.5cm)
I	10" (25cm)
J	30 3/4" (78cm)
	*
K	5 5/8"(14.5cm)
L	2" (5cm)
M	15" (38cm)
N	10" (51cm)
O	6" (15cm) min left and right side
P	13" (33cm)
Q	SPECIFY WIDTH OF HOOD
R	24" (61 cm)
S	30" min to 36" max (76-92cm)
	for standard and high back guard
S1	30" min to 33-1/2" max (76-85cm)
	for low profile back guard only
T	18" (45cm)

P

T

R

O

G S S 1

Anti-tip bracket

N

KJ

Gas Inlet

L

I

Edges of counter top

m ust be finished

cupboard depth m ust not exceed

H26”

M

Note: If range must stand beside a refrigerator, it is important for proper air circulation.There must be at least 5” (125 mm) of space between the two appliances.

*U.S. models only: J=30 1/4”

Table 2 Figure 2 5