Heat & Glo LifeStyle 6000TRS-CE manual Step Installing Flue System, Flue System Approvals

Step 3

Installing the

Flue System

A. Flue System Approvals

These models have flue starting collars on both the top and the back of the unit. Depending upon the installation, decide which ONE set of starting collars will be used to attached the flue system. The starting collar sealing cap must remain on the starting collar NOT used.

These models use DVP-series direct flue components when using the TOP and REAR flue collars.

Approved flue system components are labeled for identification.

NO OTHER FLUEING SYSTEMS OR COMPONENTS MAY BE USED. Detailed installation instructions are included with each flue termination kit and should be used in conjunction with this Installers Guide. Figure 4 shows flue system components and terminations.

Identifying Flue Components

The flue systems installed on this gas fireplace may include one, two, or three 90° elbow assemblies. The relationships of vertical rise to horizontal run in flue configurations using 90° elbows MUST BE strictly adhered to. The rise to run relationships are shown in the flueing drawings and tables on the next several pages.

Note: Two 45° elbows may be used in place of one 90° elbow. You MUST always maintain the MAXIMUM and MINIMUM rise- to-run ratios in the flue system when using 45° elbows.

	VERTICAL		STORM COLLAR
	TERMINATION
	HORIZONTAL			ROOF FLASHING
	TERMINATION
				HORIZONTAL PIPE
				SUPPORT
				PIPE LENGTH
	WALL FIRESTOP
		90 DEGREE
		ELBOW	CEILING
				WALL BRACKET
			FIRESTOP
	FLUE SYSTEM TERMINATION KITS
	DVP-SERIES
	DVP-TVHW	DVP-TRAP
	Figure 5. Flue Components and Terminations
12	Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11