Heat & Glo LifeStyle SUPREME-N-I30AU owner manual D. Placing, Securing and Leveling the Appliance

D. Placing, Securing and Leveling the

Appliance

WARNING! Risk of Explosion/Combustion Fumes! Connect vent sections per installation instructions.

•Connect exhaust vent pipe ONLY to exhaust starting collar and termination cap center collar.

•Connect inlet air vent ONLY to inlet air collar on appliance and the termination cap inlet air collar.

•DO NOT allow vent to sag below connection point to appliance.

•Remove rear leveling legs from shipping position and relocate to one of the positions shown in Figure 8.3. Remove both screws that secure the leveling leg to the side of the appliance. Turn the leveling leg around so that the foot is facing out and downward. Line up the two holes on the leg with the holes on the appliance and secure with screws. See Figure 8.3.

•Install insert (without surround attached) into existing fireplace while pulling collar slide plate forward.

•Install gas line into hole provided on side.

•If applicable install remote control wires into insert side See Section 8.E.

•Secure collar slide plate to appliance by placing locking handle into position with locking tabs (see Figure 8.1) and secure with #8 screw.

•Level the appliance from side to side and front to back. Adjust leveling bolts to desired vertical position so appliance is level. Use the leveling bolts included with the manual bag.

•A 1/2 in. (13 mm) gap from the bottom of the appliance to a metal surface is RECOMMENDED for optimal fan performance. See Figure 5.1.

•Position any excess flexible vent pipe back up into chimney without sagging. Twist and push flex vent together to shorten.

•Attach surround. Follow instructions for surround installation included with the front.

•Push insert into the opening so that it tightly overlaps the fireplace opening.

WARNING! Risk of Fire! Only an approved Hearth & Home Technologies surround may be used to cover inte- gral grills on solid fuel burning fireplaces. No other com- ponents such as shrouds, sheetmetal plates, etc., may be used to seal off vents.

WARNING! Risk of Explosion! Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

REAR LEVELING LEGS

SHIPPED IN THIS POSITION

REAR LEVELING LEGS MAY BE RELOCATED TO LOCATION A OR LOCATION B

LOCATION A

LOCATION B

Figure 8.4

Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. P • 6/12 25