Heat & Glo LifeStyle SUPREME-N-I30AU Corner Of Log Flush Withlog Tab, Front End Of Log, Spot

CORNER OF

LOG FLUSH

WITHLOG TAB

3

Figure 5. Place Log #3

Log #3 (SRV2206-702): Position Log #3 as shown in Figure 5. Position the grate tine groove, located on the bottom of the log, over the base of the left grate tine. Pull the log forward. The back end of Log #3 rests on the log support. Bend the tab located to the left of the pilot assembly into the vertical position. Rotate the end of Log #3 clockwise until the bottom right corner contacts the log tab.

FRONT END OF LOG		REST LOG ON	POINTS OF LOG REST ON
		LARGE FLAT	FLAT SPOTS
RESTS ON FLAT	4	SPOT
SPOT
			FLAT SPOTS
			(FOR LOG #6)

FLAT SPOTS	5
FOR LOG #5

GRATE TINE

TOUCHES

LOG GROOVE

Figure 6. Place Log #4 Figure 7. Position Log #5

Log #4 (SRV2206-703): Position Log #4 as shown in Figure 6. See Figure 3 for additional references. Place the thick end of Log #4 on the large flat spot on Log #1. Rest the front end of Log #4 on the flat spot of Log #2.

Log #5 (SRV2206-704): Position Log #5 as shown in Figure 7. See Figure 6 for additional details. Mate the grate tine with the log groove as shown. Position the tips of Log #5 on the flat spots as shown in Figure 6.

LEFT END OF

LOG RESTS ON

FLAT SPOT

POSITION THE NOSE ON THE

FORK OF THE LOG

6

Figure 8. Position Log #6 Figure 9. Log Set Installed

Log #6 SRV(2206-706): Position Log #6 as shown in Figure 8. See Figure 7 for additional references. Rest the left end of Log #6 on the flat spot of Log #3. Position the nose of Log #6 on the fork of Log #5.

Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. P • 6/12 49