LID Adjustment | Henny Penny 592, 590 instruction

	Model 590/592
2-14. LID ADJUSTMENT	If steam leaks out from around the lid gasket, the pressure pads
	could be worn or broken. If the pressure pad is worn, but not
	broken, it can be reversed 180 degrees, and the other end of the
	pad used. See Pressure Pad Section.
	If steam leaks, check for:

• Pressure pad wear

• Cracked or worn gasket

• Gasket installed improperly

• Fryer operating above 12 psi (827 mbar)

Fryer should be operating at 12 psi, or serious burns could result.

1103

2-11

Image 11

Henny Penny 592, 590 manual LID Adjustment

Contents

Preventive MaintenanceMaintenance Hints Introduction Checkout High Temperature Fuse Holders Limit Control Replacement Excess force will damage temperature probe Temperature Probe Replacement Yearly Inspection Every 90 days Gasket UprightReversing the LID Model 590/592 Against to seal the lid Pressure PADPressure pads are plastic strips that the lid cam presses LID Adjustment Solenoid Valve If the core-disc assembly is sticking due to buildup Solenoid Valve Deadweight Valve Removal & Cleaning Safety Relief Valve Deadweight Valve Calibration Steps Cleaning StepsValve Pressure Gauge 30 31 34 35 Contactors If either contactor proves defective, replace as follows Amperage Wires Power Heating Elements Heating Elements 4 mm Gap Out and drains the shortening out of the pot Drain valve opens when the drain valve handle is pulledDrain Valve Extension Nylatron Strips Replacement Nylatron Strips Replacement