Henny Penny 590, 592 manual Heating Elements

2-20. HEATING ELEMENTS (Continued)

2-20

Model 590/592

Replacement

1.Drain the shortening.

2.Remove the high limit bulb holder from the heating element inside the frypot.

3.Disconnect the heating element wires from the contactors. Label each so it can be replaced in the same position on the new element.

4.Remove the heat contactor, as described in Contactors Section, to access the left side element nuts.

5. Loosen the screws on the element spreaders.

6. Slide element spreaders to the center of the heating element.

7.Using a 7/8” crowsfoot, remove the brass nuts and washers which secure the ends of the elements through the frypot wall.

8. Remove the heating elements from the frypot as a group by lifting the far end, and sliding them up and out towards the rear of the frypot.

Always install new rubber O-rings (2) when installing heating elements.

9.Install new heating elements with new rubber O-rings mounted on terminal ends, and spreaders loosely mounted in the center of the stacked elements.

10. Replace the heating elements, terminal end first at approximately 45º angle, slipping the terminal ends through the front wall of the frypot.

1103