Henny Penny 592, 590 manual Heating Elements

		Model 590/592
2-20. HEATING ELEMENTS	10. Replace the brass nuts and washers on the heating element
(Continued)		terminals. Tighten the brass nuts to 30 foot lbs of torque.
	11.	Replace heat contactor.
	12.	Move the element spreaders from the center of the ele
		ment, into a position which will spread each element apart
		evenly on all four sides, and tighten.
	13.	Replace the high limit bulb holder on the top element, and
		position the bulb between the top and second element mid-
		way from side to side, and tighten screw which holds the
		bulb in place.
	14.	Reconnect the wires to the appropriate terminal as labeled
		when they were removed.
	15.	Replace the front control shroud and control panel.
	16.	Replace side panels.
	17.	Connect the power cord to the wall receptacle or close
		wall circuit breaker.

Heating elements should never be energized without shortening in the frypot, or damage to elements could result.

1103 2-21