Henny Penny 592, 590 manual If the core-disc assembly is sticking due to buildup

	Model 590/592
2-15. SOLENOID VALVE	5. If the core-disc assembly is sticking due to buildup of
(Continued)	shortening, breading, and food particles, proceed with the
	following steps:

a.Unscrew the solenoid bonnet assembly from solenoid valve body.

b.Remove solenoid bonnet assembly and bonnet gasket.

c.Remove the core-disc assembly, core spring retainer, and the core spring.

d.Wash all these parts in hot water.

If Teflon seals need to be replaced, proceed to Step 6; otherwise, assemble in reverse order of disassembly. Assemble valve core and blade with smooth side and rounded edge of blade toward the disc spring guide.

6.Repair kit, Part No. 17120, is available if any of the seals must be replaced. If one seal is defective, replace all seals.

Solenoid body must be removed from the fryer for replace ment of seals. Continue on to step 7.

7.Loosen wires on the strain relief and pull the wires through the relief.

8.With the bonnet assembly and core-disc assembly removed, disconnect the two nut fittings. One connects the solenoid valve to the deadweight, the other is attached to the condensation tank.

9.Remove the elbows from the solenoid valve.

10. Remove the two adapter screws which attach the pipe adapter to the solenoid valve body.

11.Remove the disc spring, guide, and Teflon seat.

12.Clean the valve body.

1103 2-13