Model 590/592
CABLESweight of the lid system to allow easier opening and closing of the lid. The weight has two cables attached to it, and weighs about 150 lbs. (67.5 Kg).
1.Using a 3/8” socket, remove the nuts securing rear shroud of the fryer and remove the shroud.
2.Using
3.Raise the lid.
4.Unscrew broken cable from the weight assembly and the bracket attached to the fryer, and remove broken cable.
5.Screw a 5/16” nut on each end of the new cable.
6.Using a wrench, screw new cable into the weight assembly until tight.
7.Using a 1/2” wrench, tighten nut (already threaded on the cable) against weight assembly, securing the cable into the weight assembly.
8.Pull cable over pulley and down behind weight assembly.
9.Insert cable into the hole in the bracket and screw a 5/16” nut onto end of cable. Tighten cable, by screwing the cable through this nut until the weight assembly becomes level.
The safety cable should now have slack in it with the weight assembly level.
10.Tighten nut against the top of the bracket, securing the cable.
11.Replace the top cap and rear shroud. The repair is now complete.
1103 |