High End Systems DL.2 Troubleshooting, Button Shortcut Commands, Status Message Menu Display, 219

CHAPTER 17

Maintenance and Troubleshooting

Troubleshooting

This section discusses troubleshooting LED states and general troubleshooting suggestions.

Button Shortcut Commands

DL.2 fixtures have button commands available for controlling and overriding functionality when you are troubleshooting your fixture.

•Holding the [Menu] & [Enter] buttons for more than two seconds disables motion system. Motors are still energized so unit can be pointed for trouble shooting. To Exit this mode, press the [Menu] & [Enter] buttons again for two seconds, or send a Global Reset command.

•Holding down the middle two menu Tab Select buttons for more than two seconds initiates a Global Reset of the motion hardware and homes the unit.

•Holding down the second from the top and second from the bottom Tab Select buttons for more than two seconds opens the iris when the fixture software is not running to allow navigation for content upgrades and motion uploads. To Exit this mode, press the same button combination again for more than two seconds.

Press at the same time to open Iris

Press at the same time to stop homing

Press at the same time to Home

FILTER

SERVICE

WARNING

Large Format Error/Warning Message Display

Status Message Menu Display

The DL.2 fixture menu displays error/warning information in two ways. The first is the large block format that can be viewed from a distance when the menu is idle. When there is more than one message, the large format display cycles through the messages. Each message displays for 3 seconds before cycling to the next message and continues looping through these messages until they have been cleared internally or you interact with the menu.

DL.2 Digital Light User Manual 219