English
6.Mounting Elbow (Chip Extraction Duct) (Standard Accessory)
Connect a 2 – 9/16" (65 mm) hose of dust collector to the chip extraction duct to suck cutting chips away. Mount the chip extraction duct on the chip discharge outlet at the body rear of the body.
Elbow (Chip Extraction Duct)
Fig. 11
7. Assembly of Table Saw Stand (Optional Accessory)
Leg
Stay
Washer
Cap Square Neck Bolt
Nut
Rubber Cap
Fig. | Fig. | Fig. |
Assemble it with the stay and leg(s). Set the stays below and assemble the legs outside (see Fig.
Secure with cup square neck bolts and nuts (see Fig.
Then attach rubber caps underneath the legs (see Fig.
ADJUSTMENT
This tool is accurately adjusted before shipping from the factory.
Check the following accuracies and readjust them if necessary in order to obtain the best results in operation.
WARNING: To avoid an accident or personal injury, always confirm that the switch is turned off and the power plug has been disconnected from the receptacle before adjustment of this tool.
1. Adjustment of saw blade parallel to miter gauge groove.
This is the most probably difficult of the adjustments. Before shipment from the factory this adjustment was made but it should be rechecked and readjusted if necessary.
CAUTION: This adjustment must be correct. Kickback could result and accurate cuts cannot be made.
Saw Blade
Down
Up | Loosen | |
| ||
Wheel | Tighten | |
Tilt Lock Handle | ||
|
Fig.
(1)Loosen the saw blade tilt lock handle by turning it counterclockwise. Move the saw blade tilting mechanism to the left and set the saw blade to 0° with the stopper.
(2)Turn the wheel fully clockwise and set the saw blade to the maximum cutting height (see Fig.
(3)Select a tooth on the saw blade which is bent to the right.
(4)Mark that tooth with a pencil or permanent marker.
(5)Set the miter gauge to 90° and tighten the clamp handle (B) to lock it in that position. Place the miter gauge in the left hand miter gauge groove in the table top (see Fig.
14
