English
3. Raising and lowering saw blade
Saw Blade
Down
Up
Loosen
Tighten
Wheel | Tilt Lock Handle |
Fig. 20
(1)Raising saw blade.
Grasp the wheel and rotate it clockwise to raise the saw blade.
(2)Lowering saw blade.
Grasp the wheel and rotate it counterclockwise to lower the saw blade.
CAUTION: Adjust the saw blade height so it is about 1/8" (3.2 mm) above the top of the workpiece. Raising the saw blade much higher than the workpiece does not make it cut better. It is unsafe and provides less table surface in front of the saw blade.
Never operate while saw blade rotating.
4. Saw Blade Tilting Operation
The saw blade tilt lock handle is spring loaded and can be repositioned by pulling out on the handle and repositioning it on the serrated stud located underneath the handle.
Saw Blade
Down Loosen
Up
Tilt Lock
Tighten Handle
Wheel
Fig. 21
WARNING: The saw tilt lock handle must be locked during all cutting operations.
Two methods are available tilting saw blade and are as follows.
(1)Rapid saw blade tilting.
Loosen saw blade tilt lock handle, move the wheel until the saw blade is at the desired angle and tighten saw blade tilt lock handle.
(2)Fine adjustment saw blade tilting. q Loosen saw blade tilt lock handle.
w Push in wheel until teeth on hub of hand wheel engauge with segment gear.
e Turn wheel to tilt the saw blade to the desired angle and tighten saw blade tilt lock handle.
5. Rip Fence Operation
Rip Fence
Grip
Width Body
Fig. 22
The rip fence can be used on either side of the saw blade.
The pointer on rip fence indicates the distance between the saw blade and rip fence.
(1)Raise the grip to the upside and release the fixation of the rip fence.
(2)Move the rip fence right and left while pressing the width body against the table surface and set the desired distance from the saw blade.
(3)Lower the grip to the bottom and fix the rip fence.
WARNING: The grip must be locked during all cutting operations.
Confirm the rip fence has been properly locked before operation.
To prevent personal injury, never operate the power tool if the rip fence is loose.
CAUTION: Make sure that the rip fence is always in parallel with the miter gauge groove on the table.
19
