OPTION Menu
OPTION Menu
With the OPTION menu, the items shown in the table below can be performed.
Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.
2+%674' |
| 5 #4%* |
| |||
| /#) |
|
|
| ||
| 02 |
| #76110 |
|
| |
|
| 2 |
| (( | OKP | |
126+1%4''0 | .#/2 |
| 67401((J | |||
|
| (+. |
| |||
| /+7 |
| /;$76 10 |
| ||
| '#5;/'07 | 48+%' |
|
| ||
|
|
| 5'%74+6'4;6+/' |
| ||
Item
Description
| Using the buttons ▲/▼ turns on/off the automatic signal search function. | |
| TURN ON TURN OFF | |
| When the TURN ON is selected, detecting no signal automatically cycles | |
AUTO SEARCH | through input ports in the following order. The search is started from the | |
current port. Then when an input is found, the projector will stop searching | ||
| ||
| and display the image. | |
| RGB IN1 RGB IN2 MIU COMPONENT VIDEO | |
|
| |
| Using the buttons ▲/▼ turns on/off the automatic keystone function. | |
| TURN ON TURN OFF | |
| TURN ON : Automatic keystone distortion correction will be | |
AUTO | executed whenever changing the slant of the projector. | |
TURN OFF : This function is disabled. Please execute the AUTO | ||
KEYSTONE | KEYSTONE EXECUTE in the SETUP Menu for automatic keystone | |
| distortion correction. | |
| When the projector is suspended from the ceiling this feature will | |
| not function properly so select TURN OFF. | |
| This function will be unavailable when Transition Detector is on (50). | |
| Using the buttons ▲/▼ turns on/off the AUTO ON function. | |
| TURN ON TURN OFF | |
| When set to TURN ON, the lamp will only be automatically turned on when | |
| the Power switch is turned on after the power was turned off by Power | |
| switch last time. | |
| The lamp will not be automatically turned on when the Power switch is | |
| turned on if the lamp was turned off with the following procedures. | |
| • The lamp was turned off with a remote control, projector button, or | |
| power turn off command. | |
AUTO ON | • The lamp was turned off with an AUTO OFF function (43). | |
| • The lamp was turned on by an AUTO ON function and was turned | |
| off about 30 minutes after no signal had been detected. | |
| When no input is detected after the power on and AUTO OFF time is set to 0, | |
| the projector will be turned off after about 30 minutes passed. | |
| When no input is detected after the power on and AUTO OFF time is set to | |
| 1 to 99, the projector will be turned off after the passed time reaches at the | |
| set time. | |
| If one of the projector's buttons or the remote control buttons is pressed | |
| or one of the commands (except get commands) is transmitted from the | |
| control port during the corresponding time, projector will not be turned off. |
42
