Hitachi CP-X268A user manual Image Menu, Over Scan, Position, Phase

IMAGE Menu

IMAGE Menu

With the IMAGE menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to execute the item. Then perform it referring to the following table.

	2+%674'		#5 '%6			
	/#)		18'4		%#0	
	02					
		2	*			
	126+10%4''			*#5'		
				5+<'215+6+10 
	/+7		#76 #&,756 ':'%76'
	'#5;/'07

Item	Description
	Using the buttons ▲/▼ switches the mode for aspect ratio.
	For an RGB and MIU signal
	NORMAL ó 4:3 ó 16:9 ó SMALL
ASPECT	For a video signal, s-video signal or component video signal
	4:3 ó 16:9 ó 14:9 ó SMALL
	For a no signal
	4:3 (fixed)
	• The NORMAL mode keeps the original aspect ratio of the signal.
	Using the buttons ▲/▼ adjusts the over-scan ratio.
OVER SCAN	Large (It reduces picture) ó Small (It magnifies picture)
	• This item can be selected only for a video, s-video and component signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.
	Using the buttons ▲/▼ adjusts the vertical position.
	Up ó Down
	• Over-adjusting the vertical position may cause noise to appear
V POSITION	on the screen. If this occurs please reset the vertical position to the
	default setting. Pressing the RESET button when V POSITION is
	selected will reset the V POSITION to the default setting.
	For a video signal, s-video signal or component video signal
	The adjustable range of V.POSITION depends on the OVERSCAN setting.
	It is not possible to adjust when the OVERSCAN is set to 10.
	Using the buttons ▲/▼ adjusts the horizontal position.
	Left ó Right
	• Over-adjusting the horizontal position may cause noise to appear
H POSITION	on the screen. If this occurs please reset the horizontal position to
	the default setting. Pressing the RESET button when H POSITION
	is selected will reset the H POSITION to the default setting.
	For a video signal, s-video signal or component video signal
	The adjustable range of H.POSITION depends on the OVERSCAN setting.
	It is not possible to adjust when the OVERSCAN is set to 10.
	Using the buttons ▲/▼ adjusts the horizontal phase to eliminate flicker.
H PHASE	Right ó Left
	• This item can be selected only for an RGB signal or a component
	video signal.

32