Troubleshooting
Phenomena that may be easy to be mistaken for machine defects
WARNING ►Never use the projector if abnormal operations such as smoke, strange odor, excessive sound, damaged casing or elements or cables, penetration of liquids or foreign matter, etc. should occur. In such cases, immediately turn off the power switch and then disconnect the power plug from the power outlet. After making sure that the smoke or odor has stopped, contact your dealer or service company.
1. Before requesting repair, please check in accordance with the following chart. This operation sometimes
resolves your problem.
If the situation cannot be corrected,
C |
|
|
B/PB |
|
|
C |
|
|
R/PR |
|
|
VIDEO | A | A |
| ||
S- |
|
|
SD CARD
AUXDCI/O5V
RGB IN2
CONTROL
0.5A
|
| LAN |
|
RGB | OUT |
|
|
|
| A |
|
|
| UDIO | OUT |
2. | USB |
The projector’s microprocessor may need to | |
be reset. Please push the Restart switch by using a cocktail stick or similar |
and the projector will restart.
3. Some setting may be wrong. Please use the FACTORY RESET function of the SERVICE item in the OPTION menu (45) to reset all settings to factory default.
Then, if the problem is not removed after the remedy, please contact your dealer or service company.
Phenomenon | Cases not involving a machine defect | Reference | |
page | |||
|
| ||
|
|
| |
| The electrical power cord is not plugged in. | 15 | |
| Correctly connect the power cord. | ||
|
| ||
| The power switch is not set to the on position. | 19 | |
| Set the power switch to [ ] (On). | ||
|
| ||
| The main power source has been interrupted during |
| |
Power does not | operation such as by a power outage (blackout), etc. | 19 | |
Please turn the power off, and allow the projector to cool | |||
come on. | down at least 2 minutes, then turn the power on again. |
| |
|
| ||
| Either there is no lamp and/or lamp cover, or either |
| |
| of these has not been properly fixed. |
| |
| Please turn the power off, and allow the projector to cool down | 64, 65 | |
| at least 45 minutes. After the projector has sufficiently cooled | ||
|
| ||
| down, please make confirmation of the attachment state of the |
| |
| lamp and lamp cover, and then turn the power on again. |
| |
| The signal cables are not correctly connected. | 13, 14 | |
| Correctly connect the connection cables. | ||
|
| ||
Neither sounds | Signal source does not correctly work. |
| |
nor pictures are | Correctly set up the signal source device by referring to the | – | |
outputted. | manual of the source device. |
| |
| The input changeover settings are mismatched. | 20, 21 | |
| Select the input signal, and correct the settings. | ||
|
|
66
