Hitachi DZMV380E, DZMV350E instruction manual Inserting and Removing Disc, Inserting Disc

Inserting and Removing Disc

English

INSERTING DISC

1 Press down the DISC EJECT button once and release it.

A few moments after the ACCESS/PC indicator blinks, the cover of disc insertion block will open slightly.

2 Gently open the cover by hand until it stops.

3 Insert the disc, in Round DVD Holder, into the disc guide until it stops.

Note that the recording/playback surface of disc must face the inside of DVD video camera/ recorder. The orientation for inserting the disc into the disc guide is also predetermined: Load the disc correctly, referring to the figure below.

DISC EJECT button

Disc cover

PUSH CLOSE position

If the disc is not correctly inserted, the cover will not close. Never try to forcibly close the cover: This could cause damage. Reinsert the disc properly.

Correct Incorrect

orientation orientation

Incorrect orientation

4 Push the section marked “PUSH CLOSE” on the cover of disc insertion block, to close the cover.

5 Turn the DVD video camera/recorder on (￿VIDEO or ￿PHOTO).

When “DISC ACCESS” disappears, the DVD video camera/recorder is ready for recording.

●Identifying recording/playback sides of disc:

•The disc exposed portion must face in the same direction as the lens, as shown in figure.

•The recording/playback side must face the inside (DVD video camera/recorder).

Disc guide

Single sided disc:

The recording/playback side is opposite to the printed label.

Double-sided disc:

The recording/playback side of “SIDE A” is opposite to the “SIDE A” marked side.

The recording/playback side of “SIDE B” is the “SIDE A” marked side.

“SIDE A” mark

The opposite side is the “SIDE A” recording/playback side.

42