English
The NT50AF Pneumatic Flooring Nailer and N5009AF Pneumatic Flooring Stapler have a safety trigger that prevents accidental op‑ eration if ram cap is hit while connected to power source. Squeeze safety lever to enable the Tool. Releasing the safety lever
To operate Tool, depress safety trigger while Tool is in position of use, and tap the ram cap with a minimal stroke from the hammer.
If on the first initial operation a fastener does not eject into the flooring, repeat hammer blow. This will ensure that the driver blade/Piston is properly reset to allow the driver blade/piston to be in the correct position to drive the fastener.
DO NOT OVERPOWER THE TOOL– A 90lb static force will oper‑ ate the Tool. This is easily achieved by a tap of the Hammer. If the Flooring is warped or bowed, the ram can be hit firmly to tighten the flooring. Try to avoid this constant wear, as abusive blows by the hammer could damage tool and / or internal parts.
DO NOT HIT THE TOOL HARD
This Tool is pneumatically powered and requires only actuation by depressing the safety trigger and tapping the ram head.
Note: The NT50AF Pneumatic Flooring Nailer and N5009AF Pneu‑ matic Flooring Stapler will not drive a fastener if the ram cap is struck by hammer and the safety trigger is not depressed.
The NT50AF Pneumatic Flooring Nailer and N5009AF Pneumatic Flooring Stapler are
If the fastener is not properly seated, increase pressure incremen‑ tally until fastener is seated. DO NOT EXCEED 90 PSI!
WARNING
•
•
•
Keep your finger off the trigger except during fastening opera- tion, because serious injury could result if the contact ram accidentally contacts you or others in the work area.
Keep hands and body away from the discharge area. The Tool may bounce from recoil of driving a fastener and unwanted subsequent fastener may be driven, possibly causing injury. Some types of loaded fasteners can spark out of the muzzle during a driving operation. Exercise caution!
— 24 —
