Installation, Operation, and Care of
LX SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
GENERAL
The LX Series dishwashers are fully automatic,
All LX Series dishwashers shut down automatically four hours after last use to conserve energy.
Standard equipment includes two 20" x 20" racks, electronic controls, pumped drain, fill hose and drain hose.
MODEL | DESCRIPTION |
LX18H | Washes with water from previous |
| rinse cycle, drains, and fills again with |
| fresh water for the rinse cycle. Rinse |
| is retained for the next wash cycle. |
| The LX18H has a |
| heater. |
Model LX30 Dishwasher
LX18, LX18C | Fill and drain cycle: fills, washes, drains, fills, rinses, and drains again to end |
| the cycle. |
| • LX18 requires 180°F incoming water temperature. |
| • LX18C is a |
| or 8.40% sodium hypochlorite solution (bleach) as the sanitizing agent. |
LX30 | Fresh water rinse; requires 180°F incoming water temperature. |
LX30H, LX40H | Fresh water rinse with a |
| requires 140°F incoming water and is heated in the booster to 180°F; |
| however, in the LX40H, a 70°F rise in temperature is available by using the |
| standard heavy cycle. This allows an incoming water temperature of 110°F. In |
| the LX30H, a 70°F rise is also possible; contact your local Hobart Service |
| Office. |
LX30C, LX40C | Fresh water rinse; low temperature, chemical sanitizing models for use with |
| 5.25% or 8.40% sodium hypochlorite solution (bleach) as the sanitizing |
| agent. LX30C equipped with electric booster water heater has 100°F minimum |
| water supply heated to 140°F with bleach as the sanitizing agent. |
Water usage for the LX18 models is 2.6 gallons per rack (5.2 gallons per rack if the sump water temperature cools between cycles); water usage for the LX30 and the LX40 models is 1.2 gallons per rack. The machine uses 2.2 gallons per rack for the extended rinse cycle (available on LX40 models in the heavy wash cycle only).
– 3 –
