Hobart LX30H, LX18H, LX18C, LX30C manual DELIMING - Models LX40H and LX40C, Lubrication

Models: LX18 LX30C LX30H LX40C LX30 LX18C LX18H

1 28
Download 28 pages 40 Kb
Page 25
Image 25
DELIMING — Models LX40H and LX40C

DELIMING — Models LX40H and LX40C

Models LX40H and LX40C are equipped with an automatic delime cycle reminder. After the preprogrammed number of cycles has expired, the control will indicate the delime request by illuminating DELIME. At this point, you must either enter a delime cycle or reprogram the number of cycles to terminate the DELIME indication.

1.Remove rack from machine. Close door.

2.Make sure machine is in the READY mode (READY indicated in the display).

3.To select a delime cycle, you must first enter the operator programming mode. Press and hold the HIDDEN key ("LX40" on the control panel), then press WASH. When the display indicates "-----" while illuminating both DETERGENT and PRIME, release HIDDEN key and WASH. You are now in the operator programming mode.

4.While in the operator programming mode, press the DELIME key to initiate a delime cycle. The machine will shut off the heat and will drain the water from the machine. Display will show PLEAS and WAIT. A fill cycle will then be performed.

5.After the fill cycle, the control will prompt you to add delimer by flashing "ADD" and "CHEM" with ADD and DELIME lit. Open the door and add deliming agent (carefully follow supplier's instructions). The sump holds approximately 3 gallons of water.

6.After delimer has been added, close the door. The control will flash "PRESS DELIM". Press the DELIME key again to continue the cycle. The machine will enter the wash mode for 5 minutes, then will begin two rinse and drain operations. The DELIME symbol will be lit and PLEAS and WAIT will show in the display.

DO NOT interrupt the cycle. Should the process be interrupted, restart delime procedure from the beginning.

7.After the deliming operation is completed, the DELIME and ON indicators will automatically turn off, and power to the control will be turned off.

8.Inspect the interior of the machine for lime deposits. If necessary, turn the machine ON and repeat steps 2 through 8.

CAUTION: Do not allow deliming agent to remain in the machine longer than recommended by the deliming agent manufacturer.

LUBRICATION

The pump motor has permanently sealed bearings and requires no lubrication.

– 25 –

Page 25
Image 25
Hobart LX30H, LX18H, LX18C, LX30C manual DELIMING - Models LX40H and LX40C, Lubrication