Hobart LX18C, LX18H, LX40C, LX30H, LX30C manual Cleaning - All Models

Models: LX18 LX30C LX30H LX40C LX30 LX18C LX18H

1 28
Download 28 pages 40 Kb
Page 22
Image 22
CLEANING — ALL MODELS

CLEANING — ALL MODELS

This machine must be cleaned at least once each working day. Use only products formulated to be safe on stainless steel.

1.Press OFF. The machine will drain. When the display is no longer lit, open the door and remove any debris from the bottom of the tank. Do not allow food soil to accumulate on the tank bottom.

2.Models LX30, LX30C, LX30H, LX40C & LX40H Only: Remove the lower rinse arm by unscrewing the knurled knob (Fig. 8). Remove the lower wash arm by pulling the arm off the shaft. Remove the upper rinse and wash arms in the same manner. Remove the coarse and fine strainers (see Figs. 5, 6). Thoroughly clean these items in a sink.

Models LX18, LX18C & LX18H Only: Remove the upper and lower wash arms by unscrewing the knurled knob (Fig. 8). Remove the coarse and fine strainers (see Figs. 5, 6). Thoroughly clean these items in a sink.

Knurled Knob

Model LX30

Fig. 8

PL-40093-1

Water Level Probes

Model LX30

Fig. 9

PL-40094-1

3.With a damp cloth, wipe the interior of the machine, the water level probes (Fig. 9), and the water level probe under the fine strainer. DO NOT use steel wool. Wipe the exterior of the machine. When cleaning the inside of the door, be sure to wipe the lip at the bottom of the door. Remove any remaining debris with a mild cleanser formulated for stainless steel and a soft cloth or brush.

4.Models LX30, LX30C, LX30H, LX40C & LX40H Only: Replace the coarse and fine strainers. Reinstall the lower wash arm by pushing it down on the shaft, then place the lower rinse arm on the shaft and tighten the knurled knob. Spin arms to make sure they spin freely. Repeat this procedure with the upper wash and rinse arms.

Models LX18, LX18C & LX18H Only: Replace the coarse and fine strainers. Reinstall the upper and lower wash arms and tighten the knurled knob. Spin arms to make sure they spin freely.

5.Use a soft damp cloth or sponge and mild cleanser to clean the control keypad and display. DO NOT use abrasive or harsh cleaners or scouring pads.

6.Leave the door ajar overnight to allow the interior to air out and dry.

– 22 –

Page 22
Image 22
Hobart LX18C, LX18H, LX40C, LX30H, LX30C manual Cleaning - All Models