Hobart Welding Products 210 MVP manual Connecting Optional Spool Gun, Exposed O-rings

5-15. Connecting Optional Spool Gun

7

1Drive Assembly

2Spool Gun

3Gun Securing Thumbscrew

4Gun End

Loosen thumbscrew. Insert end through opening until it bottoms

6

Spool Gun

MIG Gun

5

1 3 4 2

against drive assembly. Tighten thumbscrew.

Spool gun must be inserted completely to prevent leakage of shielding gas.

5 Gun Trigger Plug

Insert plug into receptacle, and tighten threaded collar.

6Spool Gun/MIG Gun Switch Place switch in Spool Gun position.

7Polarity Changeover Terminal Block

To make proper polarity connection, see Section 5-5.

Close door.

.Be sure that gun end is tight against drive assembly.

3

			Exposed O-rings
	Incorrect	will cause shielding			Correct
			gas leakage.
Gun Not Seated				Gun Fully Seated

9 8

10

8 Wire Feed Speed Control

Wire feed speed control controls rate at which the is fed through the

3welding gun to the weld puddle.

9 Voltage Control

Arc voltage is controlled by welding power source Voltage control (see Section 6-2or door chart for appropriate setting).

10 Trigger

Press trigger to energize welding power source contactor, start shielding gas flow, and begin wire feed.

804 695-A / 804 696-A

OM-249 498 Page 25