7-6. Replacing Switch And/Or Head Tube

! Turn Off welding power source /wire feeder and disconnect gun.

1 Remove screws (5)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2 Remove handle halves.

 

 

 

 

 

and nuts (4).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Remove screw on opposite side.

4 Secure head tube in vice.

5 Loosen jam nut. Remove from vice and turn head tube out by hand.

6 Hand-tighten head tube into cable connector.

8Remove from vice. Reposition handle halves, and install switch housing.

Tools Needed:

15 mm phillips

3Remove switch housing. Install new switch and connect leads (polarity is not important). Reassemble in reverse order. If replacing head tube, continue to end of figure.

7Place head tube in vice and tighten until nuts are tight.

9Reinstall screws and nuts.

Reinstall screw on opposite side.

243 840-A

OM-249 498 Page 32

Page 36
Image 36
Hobart Welding Products 210 MVP manual Replacing Switch And/Or Head Tube