Home Theater Direct manual Cloning MX-500ª, Adjustment of LCD Contrast

12. Cloning MX-500ª

1.Go to the SETUP mode by pressing the MAIN and ENTER buttons simultaneously for three seconds.

2.Press the CLONE button next to the LCD screen.

3.Press either the SEND or RECV button depending upon the role of the remote control. If the MX-500TMis to be copied from, press the SEND button. If it is to be copied to, press the RECV button.

4.If you wish to clone the entire device, press the ALL button. If you wish to clone only one device at a time, press the DEVIC button.

5.If you press the DEVIC button, it will show all the devices. Press the device button you wish to clone.

6.Set the MX-500TMhead to head with another MX-500TMto be cloned from as shown below. Each unit should be in either cloning from or cloning to mode based on the above steps.

OSD

ON OSD

12. Cloning MX-500ª

7.Press the START button on both units to begin cloning. It will take about 40 seconds to complete the cloning and it will flash Ò GOODÓ upon completion of the cloning.

8.Exit from the Cloning mode by pressing the MAIN button and then exit from the SETUP mode by pressing the MAIN button once again.

13. Adjustment of LCD Contrast

Pressing the MAIN button and Up on the joystick simultaneously will make the LCD contrast darker and pressing the MAIN button and Down on the joystick simultaneously will make the LCD contrast brighter.

43

44