MAINTENANCE
n Remove the screws and cylinder cover as |
| FUEL CAP | |
described previously. |
| ||
CHAIN BRAKE | CHAIN OIL | ||
n Clean the cylinder fins. | |||
| CAP | ||
n Lift the chain brake over the post. |
|
| |
n Lay the chain saw on its side with the bar and |
|
| |
chain on the ground. |
|
| |
n Remove the chain oil and fuel caps. |
|
| |
n Remove the three screws that hold the starter |
|
| |
housing in place. |
|
| |
n Lift off the starter cover and set aside. |
|
| |
n Replace chain oil and fuel caps to prevent con- |
| POST | |
tamination during cleaning. |
| ||
|
| ||
n Clean the flywheel fins. |
| STARTER | |
n Remove the chain oil and fuel caps. |
| COVER | |
|
| ||
n Replace the starter housing. Reinstall screws |
|
| |
and secure. |
|
| |
n Replace the chain oil and fuel caps. |
|
| |
n Replace the cylinder cover. Reinstall screws and |
|
| |
secure. |
|
|
n Replace the chain brake on the post.
NOTE: Check to ensure that the air filter is in the |
| |
proper position before reinstalling the cylinder | Fig. 66 | |
cover. | ||
| ||
NOTE: If you notice a power loss with the gas- |
| |
powered tool, the exhaust port and muffler may | CLEAN | |
be blocked with carbon deposits. These deposits | CYLINDER FINS | |
may need to be removed to restore performance. |
| |
We highly recommend that only qualified service |
| |
technicians perform this service. |
|
Fig. 67
CLEAN
FLYWHEEL FINS
Fig. 68
