USER FUNCTIONS
Remote Phone Control Feature
Remote Phone Control Commands
Enter User Code (within eight seconds). Upon entering remote phone control mode the Lynx will announce “System, enter code”.
To remotely disarm system: | User Code + [1] | |
To remotely arm in AWAY mode: | User Code + [2] | |
To remotely arm in STAY mode: | User Code + [3] | |
To remotely arm in AWAY or STAY mode with no delay: | User Code + [2] or [3] + [0] | |
To remotely Bypass zones: | User Code + [6] | + zone no. |
To remotely activate Forced Bypass: | User Code + [6] | + [#] |
To remotely check system status: | [✻] |
|
To end remote phone session: Hang Up or | User Code + [9] | |
Notes: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2)When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.
– 58 –
