Honeywell 800-06894 manual Arming In Away Mode

SECURING THE PREMISES

Arming the System

Arming In Away Mode

Use this mode when no one will be staying on the premises. Close all protected perimeter windows and doors before arming. The green READY indicator on the control should be lit if the system is ready to be armed. When armed in AWAY mode, the system will sound an alarm if a protected door or window is opened, or if any movement is detected inside the premises, when infrared detection devices are used. You may leave through a designated entrance door during the exit delay period without causing an alarm. You may also re-enter through the entrance door, but you must disarm the system within the entry delay period or an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter the security code to arm the system. The security code must always be used to disarm the system, however.

The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm the system. In addition, if the system is armed by pressing via Quick-Arming, neither the Babysitter Code nor Installer Code can disarm the system.

Ready To Arm

		Zones		System
Arm Away	Arm Stay	Message		Phone
Delay	10:18 AM June 8, 2010			More
				5000-100-006-V0
	Ready To Arm
Arm the system in Away mode		1	2	3
Enter Code:		4	5	6
		7	8	9
Cancel		Clear	0
				5000-100-053-V0

1.Select the Arm Away icon, the system will beep once and display a keypad.

2.Enter a valid User Code.

OR

If Quick Arm has been enabled, select the “Quick Arm” icon.

The system will beep two times and announce “Armed Away Exit Now. The exit delay screen will be displayed. If programmed the display will count down the time remaining in the exit delay in seconds.

Note: If a valid user code is not entered or the Confirm icon has not been selected within 10 seconds, the system will return to the “home” screen and it will not be armed.

– 20 –