![](/images/backgrounds/200551/200551-8018x1.png)
Installation and Setup
Camera Installation
Preparing the Camera
1.Rotate the dome bubble counterclockwise until it disconnects.
2.Pull the turret to remove it.
3.Rotate the camera counterclockwise until it disconnects from the skirt.
4.Set aside the dome bubble, turret, and camera.
Skirt
Camera
Turret
Dome bubble
Preparing the Mounting Surface
1.Mark the mounting surface for screw holes and wire access hole.
•Use the mounting template if you are surface mounting your camera. See Surface Mounting Template on page 65
•Use the flush mount adapter plate as a template if you are flush mounting your camera.
Figure
Drill these holes for the mounting screws.
Cut this hole, then pull the
power, audio, and alarm wires through it.
18