Installation and Setup

Note If your installation involves a 24V AC power source, then please wait approximately 60 seconds after connecting to a power source for video to appear on the local video out.

2.Connect the supplied video cable to the local video out connector to view the video signal on a standard monitor (see Figure 2-8below to connect a local video monitor).

3.Loosen the setscrew that locks the gimbal assembly in place (see Figure 2-8) to adjust the horizontal rotation.

4.Adjust the gimbal assembly to the desired view.

5.Re-tighten the locking screw to lock the gimbal assembly in place.

Note Figure 2-8illustrates the ways in which you can adjust your camera.

Caution Adjust the camera field of view only by moving the gimbal. Do not move the camera lens to adjust the camera field of view as this might result in irreparable damage.

Figure 2-8 Gimbal Adjustment

Setscrew (loosen to adjust horizontal rotation)

Local video out

Top view

Angle view

Legend

A = Tilt rotation

B = Horizontal rotation

C = Pan rotation

Set focal length

Loosen set screw to adjust

(bottom)

Tilt Rotation (A)

26