HD3MDIH/X EQUIP Series Indoor High Resolution True Day/Night IP Dome Camera User Guide

Flush Mount (with or without 4S box)

1.Use the screws (not supplied) to connect the adapter plate directly to the ceiling or wall.

Or

Use your own screws to connect the adapter plate to the 4S box (not supplied) which is attached to the ceiling or wall.

Note You must use screws that are able to support at least three times the weight

of the camera.

2.Connect the wires (see Connecting the Wires on page 19).

3.Secure the camera assembly to the adapter plate by twisting clockwise until it clicks securely in place.

4.Adjust the camera’s field of view (see Adjusting the Camera FOV (Field of View) on page 25).

5.Install the turret by clicking it into place.

4S box (not supplied and optional)

Adapter plate

Screws

(supplied) Screw caps

Camera assembly

Turret

Dome bubble

Note Installation with 4S box shown

6.Install the dome bubble by placing it on the camera with the tabs to the left of the slots, then turning it clockwise until the tabs click securely into place.

Restore Factory Defaults

Your HD3MDIH/X camera has a Factory Reset switch located inside the camera (see Figure 2-6on page 22). This switch restores your camera settings and passwords to their default settings. Press and hold the Reset switch for three seconds. This will reset the factory-configured parameters such as the compression settings, the camera tamper detection settings, and the Video Motion Detection settings. This will not impact network IP address configurations.

Adjusting the Camera FOV (Field of View)

To adjust your HD3MDIH/X camera:

1.Verify that power is supplied to your camera.

Document 800-07361 Rev A

25

12/10