Date and Time
Viewing the Current Date and Time
The master users can view the system time and date setting on an alpha keypad. Other users can view the time/date if a function key has been programmed to do so.
+ [#] + [6] [3]
(Master Code)
OR,
Press the function key (A, B, C, or D) for viewing current date and time, if programmed.
Alpha Display:
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
A typical time/date display is shown.
The display will remain on for about 30 seconds or until a key is pressed.
TIME/DATE SAT 12:05AM_05/09/00
“A” “B” “C” “D”
If one of the above keys has been programmed for the date/time display feature, place a check mark in the box beneath that key.
Setting the Date and Time
NOTE: All partitions must be disarmed before date/time can be set. You can set the time and date by doing the following:
1.
+[#] + [6] [3]
(Master Code)
2.Press [∗] when the time/date is displayed.
A cursor appears under the first digit of the hour. To move cursor ahead, press [∗]. To go back, press [#].
•Enter the
•Enter the
•Press [1] for PM or [2] for AM.
•Enter the last two digits of the current year.
•Enter the
•Enter the
3.To exit, press [∗] when cursor is at the last digit, or wait 30 seconds.
Alpha Display:
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
TIME/DATE SAT 04:04PM 10/17/00
Current time display
TIME/DATE SAT 04:04P2000/10/17
Time/date editing display
– 25 –
