INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING LIMITED GUIDELINES & MAINTENANCE WARRANTY

P R E - A S S E M B LY

DO NOT ATTEMPT TO LIFT THE TREADMILL!* Do not move or lift treadmill

WARNING from packaging until specified to do so in the assembly instructions. Failure to do so may result in injury! Remove plastic wrap from console masts.

Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before

completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.

A S S E M B LY STEP 1

HARDWARE BAG 1 CONTENTS :

BOLT (A)

FLAT WASHER (B)

TEFLON WASHER (C)

15 mm

20 mm

18 mm

Qty: 1

Qty: 1

Qty: 1

BOLT (D)

FLAT WASHER (E)

WAVY WASHER (F)

Qty: 1

27 mm

29 mm

 

Qty: 1

Qty: 1

 

MAIN FRAME

LEFT CONSOLE MAST

 

WAVY WASHER (F)

 

FLAT WASHER (E)

 

BOLT (D)

 

LEFT LINKAGE ARM

 

BOLT (A)

 

FLAT WASHER (B)

 

TEFLON WASHER (C)

ELEVATION FRAME

AOpen HARDWARE BAG 1.

BCut banding straps. Do not move or lift treadmill from packaging.

CMove left linkage arm into position. Insert bolt (A) and FLAT WASHER (B) into left linkage arm followed by a teflon washer (C) and attach to elevation frame.

DLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on its own.

EInsert bolt (D) and 1 FLAT washer (E) through left console mast followed by a WAVY washer (F) and attach to MAIN FRAME.

Page 8
Image 8
Horizon Fitness T82 manual S E M B LY Step