A S S E M B LY STEP 2
HARDWARE BAG 2 CONTENTS :
|
|
| ||
| 2UZ |
|
|
|
|
|
|
| |
NN |
|
|
|
|
2UZ | "3$8"4)&3 % |
|
| |
UPQWJFX | 2UZ |
|
|
|
|
|
|
| RIGHT CONSOLE MAST |
LEAD WIRE |
| MAIN FRAME |
|
|
|
|
| WAVY WASHER (F) | FLAT WASHER (E) |
RIGHT CONSOLE MAST |
|
|
|
|
CONSOLE CABLES |
|
|
|
|
|
|
|
| BOLT (D) |
|
|
|
| RIGHT LINKAGE ARM |
|
|
| FOOT LOCK LATCH |
|
| ELEVATION FRAME | CONSOLE CABLES | ||
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
A. Pull LEAD WIRE through RIGHT CONSOLE MAST. After pulling the lead wire through the mast, the top of the console cables should be located at the top of the mast. Detach and discard lead wire.
B. Open HARDWARE BAG 2.
C. Move right linkage arm into position and attach to
ELEVATION FRAME.
Note: While holding RIGHT CONSOLE MAST in the upright position, tighten
D. Attach RIGHT CONSOLE MAST to MAIN FRAME using 1 BOLT (D), 1 FLAT WASHER (E) and 1 WAVY WASHER (F).
E. Lift the running deck until lock latch on side of treadmill is fully engaged.
F.Remove console from box and place out of the way.
G.Lower the treadmill running deck from the folded position by stepping on LOCK LATCH on lower right side.
*Note: If you have attempted to move the treadmill from the box and the machine has sprung open and cannot be assembled, refer to the troubleshooting section in order to restore the treadmill to its proper position.
1 |
3 |
2 |
TREADMILL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
