|
| Maintenance Schedule (continued) |
Frequency | Area | Task |
After | Upper Bearing | Inspect. Replace both upper bearing and lower bearing if wear exceeds |
3 Years, | (extruding head); | factory recommendations. Replace the mechanical seal if the seal's contact |
then Yearly | Lower Bearing | surfaces are worn, cracked, or scratched. |
| and |
|
| (lower housing); |
|
| Mechanical |
|
| Seal; Evaporator |
|
| Cylinder; Auger |
|
C. Preparing the Icemaker for Long Storage
CAUTION
When storing the icemaker for an extended time or in
When the icemaker is not used for two or three days under normal conditions, it is sufficient to only move the power switch to the "OFF" position. When storing the icemaker for extended time or in
1.Remove the water from the icemaker water supply line:
1)Turn off the power supply, then remove the front panel.
2)Move the power switch to the "OFF" position.
3)Close the icemaker water supply line
4)Allow the line to drain by gravity.
5)Attach a compressed air or carbon dioxide supply to the icemaker water supply line drain valve.
6)Move the control switch to the "ICE" position, then move the power switch to the "ON" position. Replace the front panel in its correct position, then turn on the power supply.
7)Blow the icemaker water line out using the compressed air or carbon dioxide supply.
8)Close the icemaker water supply line drain valve.
2.Drain the evaporator:
1)Turn off the power supply, then remove the front panel.
2)Move the control switch to the "DRAIN" position, then replace the front panel in its correct position.
3)Turn on the power supply and allow the water system to drain for 5 minutes.
4)Turn off the power supply, then remove the front panel. Move the power switch to the "OFF" position.
5)Remove the evaporator drain line hose from the evaporator and attach a compressed air or carbon dioxide supply to the hose.
42
