S1 Dip Switch Mechanical, Backup, Seconds | Hoshizaki FS-1022MLH-C

f) Mechanical Bin Control Shutdown Delay (S1 dip switch 8)

Factory set for normal operation. No adjustment is required. The shutdown delay is the time between the mechanical bin control proximity switch opening and the control board shutting off the icemaker.

	S1 Dip Switch	Mechanical
	Setting	Backup
		Bin Control
	No. 8	Bin Control
	No. 8	Shutdown Delay
		Shutdown Delay

	OFF	0.25 Seconds
	ON	6.7 Seconds

g)Factory Use (S1 Dip Switch 9 & 10)

Factory set for optimum performance. Do not adjust.

21

Image 21

Hoshizaki FS-1022MLH-C service manual S1 Dip Switch Mechanical, Backup, Bin Control, Shutdown Delay, Seconds

Contents

SRC-10H Hoshizaki AMERICA, INC Contents Page Serious injury Important Safety InformationIndicates important information about the use and care Unit For SRC FS-1022MLH-C Specifications Icemaker SRC-10H Condensing Unit Icemaker FS-1022MLH-C II. General Information Construction Condensing Unit a SRC-10H Icemaking Unit Sequence Cycles and Shutdown Sequence of Operation Drain Cycle Shutdown Cycle Sequence Flow Chart Control Board Sequence Flow Chart FS-1022MLH-C/SRC-10H Control Board Control Board Control Board Layout No. of Beeps Type of Alarm Reset Options Every 5 sec LED Lights and Audible Alarm SafetiesSequence Step Energized Components Min Max Controls and Adjustments S1 Dip Switch Setting Infrared Sensor Shutdown DelaySeconds 1.6 minutes Factory Default S1 Dip Switch Setting Dispense Time S1 Dip Switch Setting Drain Timer Interval Backup S1 Dip Switch MechanicalShutdown Delay Bin Control III Wiring Diagrams Control Low-Pressure Switch Safety Low-Pressure Switch Manual ResetHigh-Pressure Switch FS-1022MLH-C with SRC-10H Performance Data IV. Service Diagnosis Diagnostic ProcedureIce Production Check Page Page Page Control Board Check 5VDC Page Infrared Sensor Check Bin Control Check Mechanical Backup Bin Control Check Page Float Switch Check and Cleaning Float Switch CheckFloat Switch Cleaning Page Diagnostic Charts No Ice ProductionNo Ice Production Possible Cause Startup No Ice Production Possible Cause Shutdown Service for Refrigerant Lines Removal and Replacement of Components Refrigerant Recovery BrazingEvacuation and Recharge R-404A Important Notes for Component Replacement Evaporator Assembly Components. See FigComponent Evaporator Assembly Upper Bearing Wear Check Removal and Replacement of Cutter Removal and Replacement of Auger Removal and Replacement of Extruding Head Removal and Replacement of Evaporator Page Removal and Replacement of Gear Motor 6b. Lower HousingPage Cleaning and Sanitizing Instructions VI. Cleaning and MaintenanceCleaning Solution Cleaning Procedure Float Switch Assembly Reservoir Cover Sanitizing Procedure Initial Sanitizing Solution Sanitizing Procedure Final Maintenance Frequency Area Task Maintenance Schedule Preparing the Icemaker for Long Storage Remove the water from the icemaker water supply lineDrain the evaporator