5)Remove all of the ice from the dispenser unit/storage bin.

6)Remove the strap connecting the spout to the chute assembly, then remove the spout. See Fig. 9.

 

Plate

 

 

 

Packing

 

 

 

Proximity Switch

 

 

Strap

Backup Bin Control Assembly Mount

 

Chute

 

Shaft

Packing

 

 

Bracket

 

Actuator

Baffle

Spout

Rubber ORing

 

 

 

 

 

 

 

 

 

 

Nylon ORing

 

 

 

 

Float Switch

 

 

 

 

Assembly

Ties

 

 

 

Reservoir Cover

(Hook and Loop)

 

 

 

Extruding Head

 

Reservoir

Reservoir

Evaporator Assembly

 

Hose

 

Chute Insulation

 

 

 

 

 

Chute

Packing

 

 

Fig. 9

Infrared Sensor Lens

7)Pour the cleaning solution over the extruding head until the evaporator assembly and the reservoir are full and the solution starts to overflow into the drain pan.

Note: If there is excess scale on the extruding head, fill the evaporator assembly and reservoir as described above, then use a clamp on the reservoir hose between the reservoir and evaporator assembly to block flow. Pour additional cleaning solution over the extruding head until the evaporator assembly is completely full.

8)Replace the spout and strap in their correct positions.

9)Allow the icemaker to sit for about 10 minutes before operation. If you placed a clamp on the reservoir hose in step 7, remove it before operation.

10)In bad or severe water conditions, clean the float switch assembly as described below.

Otherwise, continue to step 11.

a.Remove the float switch assembly from the reservoir cover.

b.Wipe down the float switch assembly with the cleaning solution.

c.Rinse the float switch assembly thoroughly with clean water.

d.Replace the float switch assembly in its correct position.

Float Switch Assembly

Reservoir Cover

Reservoir

Fig. 10

52

Page 52
Image 52
Hoshizaki FS-1022MLH-C service manual Float Switch Assembly Reservoir Cover