Hoshizaki JWE-24000CUA-L-25B D. Removal and Replacement of Gear Motor, Gear Motor Bracket Bolt

D. Removal and Replacement of Gear Motor

1)Use the “ON/OFF” button on the operation panel to turn off the unit, then turn off the dishwasher and booster tank power supplies. Lockout/Tagout to prevent the power supplies from being turned back on inadvertently.

2)Remove the front panel.

3)The gear motor is located behind the control box and at the rear left side of the machine compartment (JWE-2400CUA-L-25B) or located at the rear right side of the machine compartment (JWE-2400CUA-R-25B).

4)Disconnect the gear motor wiring at the closed end connectors.

5)Remove the bolts securing the bracket to the unit base and the nuts securing the bracket to the wash tank.

6)Loosen the 2 hexagon socket set screws for the coupling.

7)Slide up the coupling, and remove the gear motor together with the bracket.

8)Remove the gear motor from the bracket.

9)To replace, reverse the above procedure. Note:

1.Fit the coupling securely on the gear motor shaft.

2.Apply a thread sealant to the hexagon socket set screws, and tighten them securely.

3.Align the gear motor shaft with the crankshaft from the wash tank.

4.Be careful not to mix up the wire colors.

10)Make a trial run, and check for water leaks.

Bracket

(Wash Tank)

Flinger

Coupling

Hexagon Socket

Set Screw

Nut

Gear Motor

Bracket

Bolt

55