Hoshizaki KMD-410MWH, KMD-410MAH manual Water Valve, Drain Valve, Cleaning Valve

7)Remove the hose band connecting the discharge outlet and pull off the rubber hose.

8)Install the new motor in the reverse order of the removal procedure.

9)Replace the panels and front insulation in their correct positions.

10)Turn on the power supply.

12. WATER VALVE

1)Turn off the power supply.

2)If replacing the harvest and/or fill water valve, close the icemaker water supply line shut-off valve. Open the icemaker water supply line drain valve.

3)Remove the panels.

4)Disconnect the tubing attached to the valve. If replacing the harvest and/or fill water valve, loosen the fitting nut. Be careful not to lose the washer.

5)Disconnect the terminals from the valve.

6)Remove the bracket and valve from the unit.

7)Install the new valve. Replace the removed parts in the reverse order of which they were removed. If replacing the harvest and/or fill water valve, make sure the washer is in place in the fitting nut.

8)If replacing the harvest and/or fill water valve, close the icemaker water supply line drain valve. Open the icemaker water supply line shut-off valve.

9)Turn on the power supply.

10)Check for leaks.

11)Replace the panels in their correct positions.

13. DRAIN VALVE, CLEANING VALVE

1)Turn off the power supply.

2)Close the water supply tap.

3)Remove the panels.

4)Disconnect the connector of the drain valve/cleaning valve lead.

5)Remove the hose clamps at the inlet and outlet sides.

6)Remove the rubber hoses at the inlet and outlet sides.

45