Hoshizaki KMD-410MAH, KMD-410MWH manual Water Tank

7)Remove the two mounting screws.

8)Install the new valve in the reverse order of the removal procedure.

9)Open the water supply tap.

10)Plug in the icemaker or connect the power source.

11)Check for leaks.

12)Refit the panels in their correct positions.

14. WATER TANK

1)Remove the front panel, then remove the front insulation

2)Loosen the two thumbscrews securing the pump motor bracket

3)Move the control switch to the "SERVICE" position. Move the service switch to the "DRAIN" position.

4)Let the icemaker run for 2 minutes.

5)Move the control switch to the "OFF" position.

6)Turn off the power supply.

7)Disconnect the pump motor and float switch connector from the side of the control box.

8)Keep pushing up the snapping tab at the right side of the pump motor bracket.

9)Pull out the water tank, cube guide, pump motor bracket, pump motor and float switch together.

46