Hoshizaki KMD-410MWH, KMD-410MAH instruction manual Icemaker

1. Icemaker

Icemaker Water	Minimum Icemaker	Icemaker Drain	Minimum Icemaker
Supply Inlet	Water Supply Line Size	Outlet	Drain Line Size
1/2" Female Pipe	1/4" Nominal ID Copper	3/4" Female Pipe	3/4" Nominal ID Hard
Thread (FPT)	Water Tubing or Equivalent	Thread (FPT)	Pipe or Equivalent

•An icemaker water supply line shut-off valve and drain valve must be installed.

•Be sure there is sufficient extra water supply line and drain line for the appliance to be pulled out for service.

Minimum 1/4” Nominal ID

Copper Water Tubing

Icemaker Water

Supply Inlet

1/2” FPT

Icemaker Drain
Outlet
3/4” FPT	Bin

	Icemaker Water Supply Line
Icemaker	Shut-Off Valve
	Icemaker Water Supply Line
	Drain Valve
	Vent Tube
	Bin Drain Outlet	Be sure there is sufficient extra
		water supply line and drain line
	3/4”FPT
		for the appliance to be pulled
		out for service.
	Vent Tube	Separate piping to approved
		drain. Leave a 2-inch (5-cm)
		vertical air gap between the
		end of each pipe and the drain.

	2-inch
	(5-cm)
Minimum 3/4” Nominal ID	air gap
Hard Pipe
KMD-410MAH	Floor
	Drain
Fig. 9

16