Placement on the page is wrong or the edges are cut off

Possible Causes

Solutions

 

 

Auto Fit doesn’t enlarge to full size.

Note: Auto Fit will make the copy as big as possible, without

 

distorting it.

 

Make sure the copy paper size is correct.

 

Clean the glass and document cover. Any dirt or smudges on either

 

the glass or cover will be sensed by the scanner and cause the

 

enlargement to be inaccurate.

 

Check to make sure the copy paper size is correct.

 

Make sure the original is placed in the corner along the two

 

green borders.

 

 

Edges of the copy get cut off.

Press the Reduce/Enlarge button repeatedly until Entire 93%

 

appears on the display. You can also press the Plus (+) or Minus (-)

 

buttons to scroll through the available Reduce/Enlarge options. Press

 

the appropriate Start Copy button to make the copies.

 

Auto Fit will automatically reduce the copy to completely fit on the

 

page. Press the Reduce/Enlarge button until Auto Fit appears. Press

 

Start Copy.

 

 

The copy image seems to have shifted or jumped.

Copy again and be sure not to lift or press down on the document

Either the document cover was lifted or uneven

cover.

pressure was applied to the document cover during

 

copying.

 

 

 

When using A4-sized paper, the last few lines on

Set the paper-width selector on the paper tray toward the front

original do not appear on the copy. The paper size

of the tray (for A4-sized paper). Refer to Chapter 1 for these

settings are not correct.

instructions.

 

 

6-6Troubleshooting and Maintenance