1Copper-colored contacts

2Ink nozzles (do not clean)

8Slide the print cartridge back into the slot. Push the print cartridge forward until it clicks into place.

9Repeat if necessary for the other print cartridge.

10Gently close the print-carriage access door and plug the power cord into the back of the HP all-in-one.

Clean the area around the ink nozzles

If the HP all-in-one is used in a dusty environment, a small amount of debris might accumulate inside the device. This debris can include dust, hair, carpet, or clothing fibers. When debris gets on the print cartridges, it can cause ink streaks and smudges on printed pages. Ink streaking can be corrected by cleaning around the ink nozzles as described here.

Note Clean the area around the ink nozzles only if you continue to see streaks and smudges on your printed pages after you have already cleaned the print cartridges by using the control panel or the HP Image Zone. For more information, see Clean the print cartridges.

Make sure you have the following materials available:

●Dry foam rubber swabs, lint-free cloth, or any soft material that will not come apart or leave fibers.

●Distilled, filtered, or bottled water (tap water might contain contaminants that can damage the print cartridges).

Warning Do not touch the copper-colored contacts or ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

To clean the area around the ink nozzles

1Turn on the HP all-in-one and open the print-carriage access door. The print carriage moves to the far right side of the HP all-in-one.

2Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the HP all-in-one.

3Lightly press down on the print cartridge to release it, and then pull it toward you out of the slot.

one-in-all HP your Maintain

User Guide

89