
Remove the modem module:
1.Position the computer
2.Remove the two Phillips PM2.5×3.0 screws (1) that secure the modem module to the system board.
3.Lift the modem module (2) straight up to disconnect it from the system board.
4.Remove the tape (3) that secures the cable to the modem module, and then disconnect the modem module cable (4).
5.Remove the modem module.
Reverse this procedure to install the modem module.
USB connector assembly
NOTE: The USB connector assembly is included in the Cable Kit, spare part number
Before removing the USB connector assembly, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 60).
5.Remove the following components:
a.Switch cover and keyboard (see Switch cover and keyboard on page 61)
b.Optical drive (see Optical drive on page 66)
c.Speakers (see Speakers on page 69)
d.Palm rest (see Palm rest on page 71)
98 Chapter 4 Removal and replacement procedures