| |
|
|
Message | Explanation and action |
|
|
Paper not present. | The paper axis calibration routine has been triggered without having |
Load paper to print calibration | paper loaded. |
pattern | Load paper; see Advance calibration for details of the routine. |
|
|
Paper too big to scan the | During paper loading for the Calibration routine, the printer has |
pattern after printing it | detected that it will not be able to load the paper when it will be |
| needed for scanning. The minimum size required for the print is |
| 65 cm (25 in) long and 50 cm (20 in) wide. |
| Load a smaller sheet that satisfies this minimum requirement. |
|
|
Paper too big | While loading paper into the printer (roll or sheet), the printer has |
Press ENTER to retry | found that it is either too wide or too long (sheet only) to be loaded |
Press CANCEL to abort | properly. |
| Press the Enter key to load smaller paper, or the Cancel key to stop |
| the load. |
Paper too small for a diagnostic print
The Troubleshooting utility has found that the single sheet loaded in the printer is too small for a Diagnostic Print.
Load a roll of paper, or a sheet that is A3 size or larger.
Paper too small | The paper loaded is not big enough to contain the alignment pattern. |
to align printheads | Unload the paper (select Unload roll or Unload sheet from the |
Load bigger size to | Paper menu) and then load paper that is large |
align | |
Press ENTER to continue | in landscape mode for Special alignment. |
