HP 6000 manual Network Analyzer Name setting, Signal Generator Name setting, Power Meter

Chapter 1 - Installation and Configuration Software Configuration

VEE Runtime I/O Configuration

You must complete these steps for the Sofware to communicate with your network analyzer!.

1. Click Start -> Programs->Agilent VEE pro 6.0 Runtime-> I/O Config

2. Turn on you Network Analyzer and Click the “Find Instruments button.

3. You should see your network analyzer appear in the list

The instrument number consists of the GPIB controller ID number and the Instrument number

Example: ID (newinstrument@1416) 14=Nat inst

GPIB controller 16=Analyzer ID #

4.Select your analyzer from the list and Click on the “Properties button” You should see the window to the right, Change the name that is shown to one from the list below that matches your analyzer.

Network Analyzer	“Name” setting
HP 8510 series Analyzers	HP8510
HP 8714 series Analyzers	HP8714
HP 8720 series Analyzers	HP8720
HP 8753 series Analyzers	HP8753
HP 5071 series Analyzers	HP5071
Anritsu Scorpion Analyzers	Scorpion
Rhode & Schwarz RS series	RSZVR

Signal Generator	“Name” setting
HP 83650B Signal Gen.	HP836
HP 8350 Sweep Generator	HP8350
Spectrum Analyzer	“Name” setting
HP 8565 Series	HP8565

Power Meter

HP 436A Power Meter

HP 437B Power Meter

Anritsu ML2438A

Anritsu ML4803A

ELVA-1 DPM 10

“Name” setting HP436

HP437

ML2438

ML4803

DPM10

5.Press the “Advanced” button to bring up the Advanced Properties Dialog Box.

Set the Instrument Timeout to 15 seconds. Press OK , then OK, then “SAVE”. You have now successfully completed the Analyzer Configuration Process.

18