HP 66332A TRIGger, TRIGger:SOURce, TRIGger:SEQuence2, TRIGger:ACQuire

4 - Language Dictionary

TRIGger

When the transient trigger subsystem is initiated, this command generates a trigger signal. The trigger will then:

1.Initiate a pending level change as specified by CURRent:TRIGger or VOLTage;TRIGger.

2.Clear the WTG bit in the Status Operation Condition register after both transient and acquire trigger sequences have completed. (WTG is the logical-or of both transient and acquire sequences.)

3.If INITiate:CONTinuous ON has been programmed, the trigger subsystem is immediately re-enabled for subsequent triggers. As soon as it is cleared, the WTG bit is again set to 1.

Command Syntax	TRIGger[:SEQuence1][:IMMediate]
	TRIGger[:TRANsient][:IMMediate]
Parameters	None
Examples	TRIG	TRIG:IMM
Related Commands	ABOR	CURR:TRIG INIT *TRG VOLT:TRIG

TRIGger:SOURce

This command is included for completeness. It selects the trigger source for transient triggers. Since BUS is the only trigger source for transient triggers, this command does not need to be used.

BUS	GPIB device, *TRG, or <GET> (Group Execute Trigger)
	Command Syntax	TRIGger[:SEQuence1]:SOURce<source>
		TRIGger[:TRANsient]:SOURce<source>
	Parameters	BUS
	*RST Value	BUS
	Examples	TRIG:SOUR BUS
	Query Syntax	TRIGger[:SEQuence1]:SOURce?
		TRIGger[:TRANsient]:SOURce?
	Returned Parameters	<CRD>

TRIGger:SEQuence2

TRIGger:ACQuire

Agilent 66312A, 66332A Only

When the trigger subsystem is initiated, these commands generate a measurement trigger signal. The measurement trigger causes the dc source to measure the output voltage and current and store the results in a buffer.

.
Command Syntax	TRIGger:SEQuence2[:IMMediate]
	TRIGger:ACQuire:[:IMMediate]
Parameters	None
Examples	TRIG:SEQ2	TRIG:ACQ
Related Commands	TRIG:SOUR	TRIG:SEQ2:DEF TRIG:SEQ2:COUN
	TRIG:SEQ2:LEV:VOLT		TRIG:SEQ2:SLOP:CURR

74