HP 700 manual Safety Information, WARNING Potential Shock Hazard

.........................................................................................................................................................

© Copyright Hewlett-Packard Company 1998

All rights are reserved. No part of the document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett- Packard Company.

Microsoft®, Windows®, and Windows NT® are U.S. registered trademarks of Microsoft Corporation. OmniPage® Limited Edition is a U.S. registered trademark of Caere Corporation.

Publication number: C6661-90001

First Edition, October 1998

Printed in Singapore

Notice

The information contained in this document is subject to change without notice.

Hewlett-Packard shall not be liable for errors contained herein or for consequential damages in connection with the furnishing, performance, or use of this material.

Governmental regulations regarding communication can be found in the More Information guide.

Safety Information

Always follow basic safety precautions when using this product to reduce risk of injury from fire or electric shock.

1.Read and understand all instructions in the Setup Guide.

WARNING: Potential Shock Hazard

2.Use only a grounded electrical outlet when connecting the HP OfficeJet to a power source. If you don’t know whether the outlet is grounded, check with a qualified electrician.

3.Telephone lines can develop hazardous voltages. To avoid electrical shock, do not touch the contacts on the end of the cord, or any of the sockets on the HP OfficeJet. Replace damaged cords immediately.

4.Never install telephone wiring during a lightning storm.

5.Observe all warnings and instructions marked on the product.

6.Unplug this product from wall outlets and telephone jacks before cleaning.

7.Do not install or use this product near water or when you are wet.

8.Install the product securely on a stable surface.

9.Install the product in a protected location where no one can step on or trip over the line cord, and where the line cord will not be damaged.

10.If the product does not operate normally, see Troubleshooting.

11.No operator-serviceable parts inside. Refer servicing to qualified service personnel.

.......................................................................................................................................................