Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that need to be removed before installing a drive. To remove a bezel blank:

1.Remove the access panel (Access Panel on page 164).

2.Remove the front bezel (Front Bezel on page 165)..

3.To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it

(2).

Figure 8-5Removing a bezel blank

4.Replace the front bezel.

168 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis