Chapter 5: Maintenance
5-1 Lubrication
Grease all blower bearings, fan and blower motors, and pump motors that do not have permanently sealed bearings. Remove the grease relief plug (motors only) before adding grease, add grease until a small amount pours out, and replace the plug when finished.
Caution! Failure to remove the grease relief plug will result in dislodging the bearing grease seal, eventually causing bearing failure.
Refrigeration compressors are hermetically sealed and no lubrication is required.
5-2 Filter Cleaning
Air filter cleaning is important to keep your
1.Turn the chiller off.
2.Slide the filter up off of the retaining pins holding it in place along its bottom.
3.Tip the bottom of the filter away from the chiller.
4.Slide it down and out.
5.Wash down the filter with clean water (preferably with a garden hose), directing the flow of water opposite the direction of airflow. If dirt is heavy, use a mild detergent and rinse well. Allow the filter to dry completely before replacing it on the chiller.
Note: Keep a spare air filter set on hand. Install and use it while cleaning).
Caution! Do not use compressed air to blow off a dirty filter. It will not clean very well, and the filter could be damaged. Never run the chiller without properly installed filters.
Chapter 5: Maintenance | 38 of 78 |