Figure 7. HP-H!3C I/O bus converter

To install the HP A3644A SCSI adapter in an HP 9000 Series T6xx computer, perform the following steps:

1.Shut down the operating system and turn power off to the computer. (See page 15.)

2.Wear a grounding wrist strap that is connected to the HP-HSC I/O bus converter bulkhead.

3.Remove the HP-I-NC J/Obus converter from the computer. Refer to the computer system manual for instructions.

4.Grasp the SCSIadapter by its edges or faceplate. Do not touch electronic components or electrical traces. Recheck the DIP switches on the SCSI adapter for the correct settings.

Installation Procedures 26

Page 25
Image 25
HP A2969A, A3644A manual HP-H!3C I/O bus converter