HP CQ56-122NR, CQ56-110US, CQ56-100XX manual Connecting to an existing WLAN, Setting up a new WLAN

Connecting to an existing WLAN

1.Be sure that the WLAN device is on.

NOTE: Refer to Getting to know your computer on page 3 for information on identifying the location of the wireless button and wireless light on your computer.

2.Click the Network Connection icon in the notification area, at the far right of the taskbar. Available wireless networks are listed under Wireless Networks.

3.Click the correct wireless network.

If the network is a security-enabled WLAN, you are prompted to enter a network security code. Type the code, and then click OK to complete the connection.

NOTE: To connect to a network that is not automatically detected, click the Network Connection icon and select Connect to Hidden Wireless Network. Enter the ESSID information, and set encryption parameters.

NOTE: If no WLANs are listed, and your network is not hidden, you are out of range of a wireless router or access point.

If you do not see the network you want to connect to, right-click the Network Connection icon in the notification area, at the far right of the taskbar, and click Edit Connections.

Setting up a new WLAN

Required equipment:

●A broadband modem (either DSL or cable) (1) and high-speed Internet service purchased from an Internet service provider (ISP)

●A wireless router (purchased separately) (2)

●The wireless computer (3)

The illustration below shows an example of a wireless network installation that is connected to the Internet.

NOTE: Some cable modems include a built-in router. Check with your ISP to see if you need a separate router.

NOTE: When setting up a wireless connection, be sure that your computer and wireless router are synchronized. To synchronize your computer and wireless router, turn your computer and wireless router off and then back on.

As your network grows, additional wireless and wired computers can be connected to the network to access the Internet.

Using a WLAN 17